Endless connections using connection tubes

I
1. Remove a wire rod from the belt.
2. Cut this wire rod according to the figure.
3. Attention: No tubes may be inserted in driven meshes.
II Hook gear wheel edge A through both belt ends.
III Hook the final loops by means of a screw driver.
IV Thread in a wire end using pointed pliers.
V Begin of insertion of individual.
VI Completion of insertion of individual mesh B using pointed pliers.
VII
1. Push tube C on to a wire end.
2. Push the wire lying opposite into the other opening in the tube (using two pointed pliers makes this easier).
3. The tubes can be fixed by squashing the ends by means of pliers.
4. If necessary: Straighten bent wire pieces.
VIII The rod network belt is ready for use.